In order to give you a better service Pepperl+Fuchs uses cookies. By continuing to browse the site you are agreeing to our use of cookiesI agree.
Serviceline Industrial Sensors
Sales phone: 0161 622 6308
Tech phone: 0161 622 6311
Fax: 0161 624 6537
Serviceline Explosion Protection
Sales phone: 0161 622 6309
Tech phone: 0161 622 6313
Fax: 0161 624 6537

Validating DART Fieldbus: Three Simple Steps

“The Simplicity of Intrinsic Safety” from our perspective means that your job should be as simple as it can be. This includes validation of intrinsic safety. With DART Fieldbus this is possible through a system certificate covering all practical scenarios of application.

Without the need to consider anything out of the ordinary you can focus on getting your fieldbus installation up and running. No calculations! Use:

1. Type 'A' fieldbus cable
2. Up to 1000 m trunk cable
3. Only DART Power Hub and DART Segement Protectors.

Install one redundant DART Power Hub in the control room at one end of the trunk. Install up to four DART Segment Protectors at any location on the trunk. Long cable runs for both trunk and spurs are yours to apply as you need them. That’s it.

Intrinsically safe trunk and spurs; Ex ib IIC for Zone 1; easy to understand, easy to engineer

DART Fieldbus Products